Question

What specific technical goal is achieved by applying a &#x27;deadband&#x27; to an alarm setting?

Accepted Answer

A deadband is a small buffer zone around an alarm point that stops the alarm from rapidly clicking on and off. Without a deadband, if a sensor reading hovers exactly at the alarm limit, a tiny flicker in the signal would cause the alarm to repeatedly trigger and silence. This constant switching is called chattering, which is annoying and can wear out equipment. By using a deadband, you tell the system that once the alarm goes off, the reading must move a certain distance past the limit before it is allowed to turn off again. Think of it like a thermostat in a house that does not turn the heat off the exact second the air hits the target temperature, but waits until it gets a few degrees warmer so the furnace does not keep starting and stopping every few seconds. The goal is to keep the system stable and quiet by ignoring tiny, unimportant changes right at the edge of the limit.

What specific technical goal is achieved by applying a 'deadband' to an alarm setting?

A deadband is a small buffer zone around an alarm point that stops the alarm from rapidly clicking on and off. Without a deadband, if a sensor reading hovers exactly at the alarm limit, a tiny flicker in the signal would cause the alarm to repeatedly trigger and sile....

Community Answers

Home → All Courses → Engineering and Technology Courses → Strategic Alarm Management → Flashcard

What specific technical goal is achieved by applying a 'deadband' to an alarm setting?

A deadband is a small buffer zone around an alarm point that stops the alarm from rapidly clicking on and off. Without a deadband, if a sensor reading hovers exactly at the alarm limit, a tiny flicker in the signal would cause the alarm to repeatedly trigger and sile....

Community Answers